Dynamic materials testing Load range 100 kN |
|
Tester | Dynamic material testing machine INSTRON 8501, servo-hydraulic static and dynamic testing machine with climatic chamber (-40 to +200 °C; maximum 90 % relative humidity) |
Application | Tensile, compression and bending tests, fatigue strength; preferably for plastics and textiles (metallic materials on request) |
Load range | Axial nominal force up to ±100 kN |
Piston stroke | Up to 100 mm |
Piston velocity | Up to 0,8 m/s |
Frequency | Maximum 40 Hz at 0.1 mm amplitude |
Deformation measurement | - Measurement over piston stroke
- Depending on the sample geometry directly with extensometer for round and flat samples
|
Sample geometry | - Moulded parts up to 20 mm thickness using hydraulic specimen grips up to 100 kN
- Round specimens up to 12 mm diameter using hydraulic specimen grips up to 100 kN
- Larger specimen dimensions possible with lower loads
- Moulded parts and assemblies by using suitable adapters
|
Multiaxial dynamic test bench |
|
Tester | Zwick GmbH & Co. LIMITED PARTNERSHIP |
Application | Dynamic (tensile) tests on fibre and wire ropes in the diameter range 2 - 12 mm |
Vertical axis | - Maximum force 100 kN
- Maximum piston travel 150 mm static or ± 75 mm dynamic
- Amplitude ± 5 mm at approx. 6 Hz
- Force transducer with 25 kN for lower loads
|
Horizontal axis | - Maximum force 10 kN
- Maximum piston travel 250 mm static or ± 125 mm dynamic
- Amplitude ± 5 mm at approx. 11 Hz
|
Torsion axis | - Maximum torque 1000 Nm
- Maximum torsion angle: 100° static or ± 50° dynamic
- Amplitude: ± 5° at approx. 10 Hz
|
Temperature range | -40 °C to 250 °C, continuous operation at maximum 180 °C |
Humidity range | 10 % to 95 % at 20 °C to 90 °C |
Heating rate | 1 K/min |
Test room, climate chamber | Height 1150 mm, width 630 mm, depth 650 mm |
Sample geometry | Components and assemblies |